TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
8.1.2. Positioning distance relative to the parts to mark
The distance between the stylus and the part to be marked is very important, as it can affect the depth and quality of
the marking (homogeneity of point depth and their alignment) according to the machine setting.
The following illustrations show the nominal case position which is recommended by Technomark.
In the following diagram the machine is shown with the standard stylus (length 60mm, sharpened to 90°). In the case
of an extended stylus (length 100mm) 40mm must be added to the distances measured in relation to the surface of
the part to be marked: below.
8.1.2.1. Recommended distance
Illustration 28: Nominal stylus part distance (rear view)
Without the IDI function the different marking strengths means that a gradual depth can be obtained over
3mm
To Next Page
Loading...
