TP8-96 VIDEO - Installer Manual Programming of zones and programs
2-19
PROPERTIES KEY ZONE
The key zone can be set so as to work in the following way:
z ON/OFF
On/Off or switch functioning is indicated if an ON/OFF key is
connected to the key zone.
z Pulse
Pulse functioning is indicated if a push-button is connected
to the key zone.
SINGLE ARMING BY KEY
The keys can be enabled for merely single arming. In this way,
upon every introduction of the key into the key reader another
program it is enabled for will be selected whereas the previous one
is deselected.
COUNTRY
Permits to set the special versions depending on the country of
destination.
MODIFICATION OF CODE BY USER
By default the master code is the only one enabled for the
modification of the user codes. If the item is checked the standard
users are enabled for the modification of their proper code, but
cannot view nor modify the other codes.
INVERSION OF DIGITS OF REPORT CODES
Permits the inversion of the report codes to be sent during the
digital transmissions.
To be used only if specifically requested.
LEVEL OF WIRELESS TRANSMISSION
Every level of wireless transmission a different output power of the
wireless receiver-transmitter corresponds to.
AUTOMATIC TAMPER DISABLING
Permits the self-exclusion of the tamper alarms, if a determined
number of tamper alarms is counted in a determined period of time.
z Disabled
z Automatic tamper disabled after 1...255 alarms (cycles)
TAMPER RE-ENABLING AFTER
Permits programming of the period of time (in hour and minutes)
after which the tamper control is re-enabled.
ANTIMASKING CONTROL ZONE
Permits setting of the antimasking control of the zones:
z Always active
z Alarm if program armed
z Alarm and signaling if program armed
Check the corresponding item to enable the option, then press:
z OK to confirm and close the zone configuration
tables
z Abandon to undo the system option settings
WARNING
Valid for the key readers connected via key interface TP SKN only, but not for the key reader with
mini keypad TP SK6N.
WARNING
Prior to setting the level of wireless transmission check for possible output power limitation in your
country.
To Next Page
