TP8-96 VIDEO - Installer Manual Programming of telephone section
3-3
z Vocal
The communicator block affects only those channels transmitting voice messages.
• Single channel
Upon reception of the blocking command the active call is interrupted and the alarm call cycle of the active voice
channel is blocked.
• All channels
Upon reception of the blocking command the active call is interrupted and the alarm call cycles of the active voice
channel as well as all the other voice channels programmed for the event are blocked.
z Digital
The communicator block affects only those channels using digital non-Tecnoalarm formats.
• Single channel
Upon reception of the blocking command the active call is interrupted and the alarm call cycle of the active digital
channel is blocked.
• All channels
Upon reception of the blocking command the active call is interrupted and the alarm call cycles of the active digital
channel as well as all the other digital non-Tecnoalarm channels programmed for the event are blocked.
z Tecnoalarm
The communicator block affects only those channels using the digital Tecnoalarm format.
• Single channel
Upon reception of the blocking command the active call is interrupted and the alarm call cycle of the active digital
Tecnoalarm channel is blocked.
• All channels
Upon reception of the blocking command the active call is nterrupted and the alarm call cycles of both the active
and all the other digital Tecnoalarm channels programmed for the event are blocked.
z All
The communicator block affects all the telephone channels independently from the protocol they use.
• Single channel
Upon reception of the blocking command the active call is interrupted and the alarm call cycle of the active channel
is blocked.
• All channels
Upon reception of the blocking command the active call is interrupted and the alarm call cycles of the active and
all the other vocal and digital channels programmed for the event are blocked.
FUNCTIONS
z Check ringback
If enabled, the control panel waits for the ringback tone before it transmits a message.
z Opening message
This function is valid only for the voice protocols.
If the function is enabled, the control panel transmits the opening message before the alarm message. If the function
is disabled, the control panel transmits only the alarm message.
See § 3.2 for explanatory notes.
Press:
z OK to confirm and quit
z Abandon to quit without saving
WARNING
The voice channel can be blocked only by pressing the key * or # on the telephone dial.
Any voice command is ignored.
WARNING
The digital non-Tecnoalarm protocols are to devide in single type and multiple type protocols.
In any case, both if a single type protocol is programmed or not, the other events are transmitted. No
event will be lost due to the communicator block!
Single type protocols transmit one event at a time, i.e. they close down the communication once the
event has been transmitted and recall to transmit the next one. The multiple type protocols transmit
the entire queue of events before they close down the communication.
To Next Page
