TECO E510s Series - Page 191

4-125
functions 1 to 6.
 The time charts of the frequency agree detection operation are shown in table 4.3.30.
Function
Detection operation of frequency
confirmation
Description
Frequency
agree
time
time
ONOFF
FWD
REV
03-14
03-14
Freq
Reference
Output
Frequency
Frequency
Agree
Signal
ON
Freq
Reference
 Output is active when the output
frequency falls within the frequency
reference minus the frequency
detection width (03-14).
 Any of the digital outputs function
(03-11, 03-12 or 03-28) can be set to 2
(Frequency agree).
Set
frequency
agree
time
time
ONOFF
FWD
REV
03-14
Output
Frequency
Setting
Frequency
Agree
Signal
ON
03-13
03-13
03-14
 Output is active the output frequency
falls within the frequency detection
width (03-14) of the set frequency
detection level (03-13).
 Any of the digital outputs function
(03-11, 03-12 or 03-28) can be set to 3
(Set frequency agree).
Output
frequency
detection
1
ON ONOFF OFF
03-14
03-14
03-13
03-13
03-13
03-13
tim
e
tim
e
Output
Frequency
Output
Frequency
Detection 1
Signal
 Output is active when the output
frequency rises above the frequency
detection level (03-13) + frequency
detection width (o3-14) and
deactivates when the output
frequency falls below frequency
detection level (03-13).
 Any of the digital outputs function
(03-11, 03-12 or 03-28) can be set to 4
(Output frequency detection 1).
Output
frequency
detection
2
 Output is active when the output
frequency is below the frequency
detection level (03-13) + frequency
detection width (03-14) and turns off
when the output frequency rises above
below frequency detection level.
 Any of the digital outputs function
(03-11, 03-12 or 03-28) can be set to 5
(Output frequency detection 2).
Frequency
Output
DC BrakeDC Brake
ON ONOFF OFF
Output
Frequency
Frequency
Output
Ing
OFF
OFF
OFF
OFF OFF
ON
ON
Run
command
Base
Block
 When the inverter output frequency is
active, the output terminal is closed.