18 V8-U-TXT.PM6 : Issue I , Revision I : October 1997
DISARMING YOUR SYSTEM
b/Disarm individual areas
? ~ Enter the area number
ENTER ~ Press
This will disarm the selected area immediately and remove it from the display.
If there are more areas than can be shown on the display the list will now show the next area.
You may disarm any of the areas listed by selecting them in this way.
When disarming is complete, press ENTER to return to the display shown in step 1.
c/Cancel the function
ENTER ~ Press
This will cancel the function and return you to the display shown in step 1. If you have already disarmed areas
prior to using this function, the areas will remain disarmed.
d/Display more areas
NEXT ~ Press
This will display the next armed areas in the list and update the information. Select from these areas to disarm
the individual area (as shown in b/ above) or continue to press NEXT to view all the areas and return to the
first display.
4. The area light(s) will extinguish when the disarming procedure has been successful.
Reset an Alarm:
1. Resetting an alarm is the same as the disarming procedure except that the initial display will show:
Code:
2. Steps 2 & 3 of the disarming procedure can then be followed.
3. If the reset function is successful:
- The area light stops flashing and returns to the off state.
- The display will return to "There Are No Alarms In This Area", or the custom text programmed
for your system.
See Also: Alarm
www.msealarms.com.au
To Next Page
Loading...
