Data Section ContentsDescriptionTextReturn
Code
IP address information
of client that already has
the write transaction.
Another client already has a write
transaction open.
WRITE_UNAVAIL
1005
data (id
<connection id>,
ip <ip addr>, port
<port num>)
Retrieve IMEI Data
This command displays the provisioned IMEI data.
Retrieve All the Data Associated with a Single IMEI Entry
This command is used to retrieve the IMEI data specified. If the IMEI specified is not found in the
individual entry table but resides in an IMEI block, then that IMEI block will be displayed.
The rtrv_eir command defines the request message to retrieve all the data associated with a single
IMEI entry.
Parameters :
A single IMEI.
imei
14 or 15 hexadecimal digits expressed using ASCII characters. Only
the first 14 digits of the IMEI are stored and displayed on retrieval.
Values:
Rules
1. If the imei includes the optional 15th character (the check digit), the check digit is provided by the
Customers Client Software and must match the EPAPs (via calculated algorithm). The check digit
is not stored; it is only used to verify the imei.
Request syntax:
rtrv_eir([iid XXXXX,] imei XXXXX)
Retrieve IMEI Data: Retrieve a Range of IMEIs
This command is used to retrieve either a range of individual IMEI(s) or IMEI blocks.
Parameters :
The beginning IMEI in a block.
bimei
129
910-6022-001 Revision A, March 2011
PDBI Request/Response MessagesProvisioning Database Interface Manual
To Next Page
Loading...
