Tekelec EAGLE 5 - Synchronous Service Module Card Report; Table 40: Synchronous Service Module Card Report Example

DescriptionMessage
10 seconds later, another report
comes out. Now, the loading card
→
dsmrpt (rc 0, data (segment 1, level 2917,
percent 95, numdsms 20, dsms (dsm (clli
←
is finished, but the corrupt card
is still corrupt.
lakemary, cardloc 2104, status corrupt,
level 2652))))
The client is done and has
disconnected.
disconnect(iid 7)
→
Synchronous Service Module Card Report
This example shows a connection that uses the rtrv_dsmrpt request to receive the Service Module card
Report.
Table 40: Synchronous Service Module Card Report Example
DescriptionMessage
A normal PDBI connection has
been established. At this point, it
connect(version 1.0)→
rsp (rc 0, data (connectId 1, side active))←
has not expressed any desire to
get a Service Module card Report.
The connection requests a Service
Module card Report with a
rtrv_dsmrpt(percent 90)→
rsp (rc 0, data (segment 1, level 2912, percent 90, numdsms
20, dsms (dsm (clli atlanta, cardloc 1405, status coherent,
←
specific percent complete value
of 90. The level 2912 is returned
because only two Service Module
level 2910), dsm (clli lakemary, cardloc 2104, status corrupt,
level 2652))))
cards out of the known 20 have
not reached that level.
The connection requests the
Service Module card Report
rtrv_dsmrpt(percent 95)
→
rsp (rc 0, data (segment 1, level 2910,
percent 95, numdsms 20, dsms (dsm (clli
←
again, this time with a more
stringent percent complete value
lakemary, cardloc 2104, status corrupt,
level 2652))))
of 95. This time, a smaller level of
2910 is returned in order to satisfy
the higher percent value.
The client is done and has
disconnected.
disconnect(iid 7)
→
157
910-6022-001 Revision A, March 2011
PDBI Sample SessionsProvisioning Database Interface Manual