Update Network Entity
The upd_entitycommand modifies an entity object (such as an SP) and its corresponding global
title translation.
Spare point codes, indicated by an optional s- prefix, are supported for Network Entities with a pctype
of intl and natl.
Update Network Entity Request
Parameters :
Global title address for this network entity.
id
1 to 15 hexadecimal digits expressed using ASCII characters.
Values:
Type of network entity being updated.
type
SP – Signal Point
Values:
RN – Routing Number. (G-Flex only customers do not use RNs. Used
for A-Port and IS41 GSM Migration features.)
VMS – Voicemail Server. (Used for V-Flex customers.)
GRN – Generic Routing Number
(Optional) Specifies the type of the point code. If the pctype of an existing NE is changed,
then the pc parameter must also be specified.
pctype
Values:
intl - ITU international point code in the form zone-area-id (z-aaa-i).
natl - ITU national point code in the form of ITU number (nnnnn).
nl24 - ITU national 24-bit point code in the form of msa-ssa-sp (mmm-sss-ppp).
ansi - ANSI point code in the form of network-cluster-member (nnn-ccc-mmm).
none - No point code specified. (Only valid for RNs , VMSs, and GRNs.)
(Optional) Point code value. The valid values depend on the pctype parameter. If no
pctype parameter is specified, the pctype of the existing instance is used.
pc
For pctype of intl the format is zone-area-id [(s-)z-aaa-i].
Values:
s - Optional spare point code indicator
z= 0 – 7
aaa= 0 – 255
i= 0 – 7
Note: The value 0-0-0 is not valid.
102
910-6022-001 Revision A, March 2011
PDBI Request/Response MessagesProvisioning Database Interface Manual
To Next Page
Loading...
