Request syntax:
dlt_eir([iid XXXXX,]imsi XXXXX)
Delete IMEI Data Responses
The return codes in Table 21: Update IMEI Response Return Codes may result from the Delete IMEI
request. See PDBI Message Error Codes for the recommended actions to help resolve the error related
return codes.
Table 21: Update IMEI Response Return Codes
Data Section ContentsDescriptionTextReturn
Code
NONEEverything worked.SUCCESS
0
The offending field is
returned in the data
section:
One of the fields specified had an
invalid value.
INVALID_VALUE
1012
data (param <field
label>)
imei, bimei, or eimeiThe check digit provisioned did not
match the calculated check digit.
CHECK _DIGIT _ERROR
1037
data (param imei xxxxx)
NONEThe requested IMEI or IMEI block
was not found.
NOT_FOUND
1013
NONEIMSI not found on specified IMEI.IMSI_NOT_FOUND
1038
NONE
The delete command was sent on
a read only transaction.
WRITE_IN_READ_TXN
1011
NONEThis request would cause current
transaction to be larger than limit.
TXN_TOO_BIG
1029
NONEThe database already contains the
data in the request. No update was
necessary.
NO_UPDATES
1017
NONEThere was no currently active
transaction for this connection.
NO_ACTIVE_TXN
1009
NONEThe PDBI client making request does
not have write access permissions.
NO_WRITE_PERMISSION
1006
128
910-6022-001 Revision A, March 2011
PDBI Request/Response MessagesProvisioning Database Interface Manual
To Next Page
Loading...
