Tekelec EAGLE 5 - Subscription Management Commands

Table 7: Abort Transaction Response Return Code
Data Section ContentsDescriptionTextReturn
Code
NONEAbort successful.SUCCESS
0
NONEThere was no currently active
transaction for this connection.
NO_ACTIVE_TXN
1009
Create Subscription
Create Subscription messages define different combinations of subscriptions by using the ent_sub
command with a different set of parameters. The following subscriptions can be created:
• Subscription containing a single IMSI with no DNs
• Subscription containing an IMSI and one to eight DNs
• One or more DNs on the same NE with no IMSI
• Subscription porting a block of DNs
When a request to create a subscription fails due to provisioning checks added for the EPAP
Provisioning Blacklist feature, the beginning (bprovbl) and ending (eprovbl) address string of the
conflicting EPAP Provisioning Blacklist will be returned in the response.
Subscription Containing a Single IMSI with No DNs
This command attempts to create an IMSI record that contains no DNs. By default, if the IMSI already
exists, the command is rejected. Using the optionalforce parameter changes the default behavior to
overwrite an existing IMSI. If the existing IMSI that is overwritten has DNs, those DNs are deleted. If
the IMSI conflicts with an entry in the EPAP Provisioning Blacklist table, the command will be rejected
and use of the optional force parameter will not override this function.
Note:
Only the G-Flex feature uses this type of subscription data.
The ent_sub command defines the request message for a subscription containing a single IMSI with
no DNs.
Parameters :
A single IMSI.
imsi
5 to 15 hexadecimal digits expressed using ASCII characters.
Values:
Specifies which SP the IMSI is on. The sp must correspond to an existing SP entity.
sp
1 to 15 hexadecimal digits expressed using ASCII characters.
Values:
61
910-6022-001 Revision A, March 2011
PDBI Request/Response MessagesProvisioning Database Interface Manual