Tekelec EAGLE 5 - Table 23: Retrieve Service Module Card Report Response Return Codes

The database status of the Service Module card.
status
Values: loading - The card is currently loading the database.
resync - The card is loaded, but catching up to current provisioning stream.
coherent - The database is loaded and receiving normal provisioning
incoherent - Internal error on Service Module card (write failed to database)
inconsistent - Data mismatch between EPAP RTDB and Service Module
card RTDB.
corrupt - Internal error on Service Module card checksum failure).
level - The database level for this card.
Values: 0 – 4294967295
loadperc - The percent of the database that has been loaded during initial
booting of the card. This field is only meaningful when the status is loading,
so it will only appear then.
Values: 0 – 100
rsp([iid XXXX,] rc 0, data (segment ###, level ####, percent <0..100>, numdsms ####,
dsms (
dsm (clli AAAA, cardloc ####, status <values below>, level #### [, loadperc
<0..100>]),
. . .
dsm (. . .) ) )
The return codes listed in Table 23: Retrieve Service Module Card Report Response Return Codes indicate
the result of the Retrieve Service Module card report request. See PDBI Message Error Codes for the
recommended actions to help resolve the error related return codes.
Table 23: Retrieve Service Module Card Report Response Return Codes
Data Section
Contents
DescriptionText
Return
Code
See above.Everything worked.SUCCESS
0
Offending field is
returned in data
section:
One of the fields specified had an invalid
value.
INVALID_VALUE
1012
data (param <field
label>)
Depends on the
request type, etc.
The request has succeeded, but this is only
one of many responses.
PARTIAL_SUCCESS
1016
134
910-6022-001 Revision A, March 2011
PDBI Request/Response MessagesProvisioning Database Interface Manual