Retrieve Service Module Card Report
There are two parameters that adjust what percent or level to run the report for. The two parameters
are mutually exclusive. If neither is specified, then the report will be run with the default percent value
for the connection. The caller can also specify whether or not they want the Service Module card
exception list.
The rtrv_dsmrpt command defines the request message to retrieve the Service Module card report
data.
Parameters :
(Optional) The percent to use for this one report. Cannot be specified with level.
percent
1 – 100
Values:
(Optional) Specific database level to use for this one report. Cannot be specified with
percent.
level
1 – 4294967295
Values:
(Optional) Lets the requester specify whether or not they want to the see list of
Service Module cards that were not at the main database level mentioned in the
report.
data
status (default) - Return the list of Service Module cards.
Values:
none – Do not return the list of Service Module cards.
Request syntax:
rtrv_dsmrpt([iid XXXXX,] [percent ###], [level #####], [data
<none/except>])
Retrieve Service Module Card Report: Response
The data section of a successful Service Module card report request contains the following information:
Parameters :
This parameter contains the message segment number.
segment
Values: ≥ 1 – Incrementing integer starting from 1.
The database level that the report is referring to. The Service Module cards that satisfy
the report have levels equal to or greater than this value.
level
Values: 0 – 4294967295
The percentage of known Service Module cards that meet or exceed the level
percent
135
910-6022-001 Revision A, March 2011
PDBI Request/Response MessagesProvisioning Database Interface Manual
To Next Page
Loading...
