Tekelec EAGLE 5 - Page 136

specified.
Values: 0 – 100
The total number of known Service Module cards in the
customer's network.
numdsms
Values: 0 – ####
List of Service Module cards that did not have a database level equal to or larger than
main message's level. Each Service Module card contains the following information.
dsms
Identifier for the Service Module card's EAGLE 5 ISS node. Values: String
up to 11 characters long
clli
Location identifier for the Service Module card in the EAGLE 5 ISS node.
Values: Four digit number
cardloc
The database status of the Service Module card.
status
Values: loading - The card is currently loading the database.
resync - The card is loaded, but catching up to current provisioning stream.
coherent - The database is loaded and receiving normal provisioning
incoherent - Internal error on Service Module card (write failed to database)
inconsistent - Data mismatch between EPAP RTDB and Service Module
card RTDB.
corrupt - Internal error on Service Module card checksum failure).
level - The database level for this card.
Values: 0 – 4294967295
loadperc - The percent of the database that has been loaded during initial
booting of the card. This field is only meaningful when the status is loading,
so it will only appear then.
Values: 0 – 100
rsp([iid XXXX,] rc 0, data (segment ###, level ####, percent <0..100>, numdsms ####,
dsms (
dsm (clli AAAA, cardloc ####, status <values below>, level #### [, loadperc
<0..100>]),
. . .
dsm (. . .) ) )
The return codes listed in Table 24: Retrieve Service Module Card Report Response Return Codes indicate
the result of the Retrieve Service Module card report request. See PDBI Message Error Codes for the
recommended actions to help resolve the error related return codes.
136
910-6022-001 Revision A, March 2011
PDBI Request/Response MessagesProvisioning Database Interface Manual