Tekelec EAGLE 5 - Table 22: Retrieve IMEI Response Return Codes

0 - 40000000
Values:
Rules
1. If the imei includes the optional 15th character (the check digit), the check digit is provided by the
Customers Client Software and must match the EPAPs (via calculated algorithm). The check digit
is not stored; it is only used to verify the imei.
Request syntax:
rtrv_eir([iid XXXXX,] bimei XXXXX, eimei XXXXX, [type
<block/single>,] [white <yes/no>,] [gray <yes/no>,] [black
<yes/no>,] [imsi XXXXX] [data <all/count>] [num 0..40000000])
Retrieve IMEI Data Responses
The syntax of the data section of responses to a successful Retrieve IMEI request depends on the type
of records being returned. Both single IMEI and range IMEIs data is supported. Each type of data
being returned has a different syntax.
• Response syntax for an IMEI single query:
data (segment XXXXX,
imeis (imei(id XXXXX, svn ##, white yes/no, gray yes/no, black yes/no, [imsis
(xxxxx, .... xxxxx....)),
. . .
( . . . ) ) )
• Response syntax for an IMEI block query:
data (segment XXXXX,
meiblock (imeiblock (bimei xxxxx, eimei xxxxx, white yes/no, gray yes/no, black
yes/no, ),
. . .
( . . . ) ) )
• Response syntax for an IMEI count query:
data (counts (imei #####)
data (counts (imeiblock #####)
The return codes listed in Table 22: Retrieve IMEI Response Return Codes indicate the result of the Retrieve
IMEI request. See PDBI Message Error Codes for the recommended actions to help resolve the error
related return codes.
Table 22: Retrieve IMEI Response Return Codes
Data Section
Contents
DescriptionText
Return
Code
NONEEverything worked.SUCCESS
0
131
910-6022-001 Revision A, March 2011
PDBI Request/Response MessagesProvisioning Database Interface Manual