Recommended ActionTextError Code
Reattempt this command after the read
transaction is terminated and a write
transaction is opened.
PDBI_WRITE_IN_READ_TXN1011
Re-enter the command using the correct
value in the offending field returned in the
data section.
PDBI_INVALID_VALUE1012
This error is dependent on the contents of
the database. No action is required, unless
PDBI_NOT_FOUND1013
it is known that the item in question should
be in the database. If this is the case, contact
Tekelec.
Using the force parameter can override this
check and eliminate the return of this error
code for certain commands.
PDBI_CONFLICT_FOUND1014
No action necessary. The PDB already has
the requested entry in the database.
PDBI_ITEM_EXISTS1015
No action necessary. This error indicates
that more messages are to follow.
PDBI_PARTIAL_SUCCESS1016
PDBI_SUCCESS will be returned to indicate
the last message has been sent.
No action necessary. The PDB already has
the requested entry in the database.
PDBI_NO_UPDATES1017
There is a problem with the syntax of the
command. Refer to the data section of the
PDBI_BAD_ARGS1019
response message to determine what
problem was encountered.
One of the PDBI connections needs to be
terminated before this client can gain a
connection.
PDBI_TOO_MANY_CONNECTIONS1020
No action required unless it is known that
the NE in question is/should be in the
PDBI_NE_NOT_FOUND1021
database. If that is the case, please contact
Tekelec.
162
910-6022-001 Revision A, March 2011
PDBI Message Error CodesProvisioning Database Interface Manual
To Next Page
Loading...
