Maintenance—455/A2/B2
REPACKAGING FOR SHIPMENT
If the Tektronix instrument is to be shipped to a Tektronix
Service Center for service or repair, attach a tag showing:
owner (with address) and the name of an individual at your
firm that can be contacted, complete instrument serial
number and a description of the service required.
Save and re-use the package in which your instrument was
shipped. If the original packaging is unfit for use or not
available, repackage the instrument as follows:
1. Obtain a carton of corrugated cardboard having inside
dimensions of no less than six inches more than the
instrument dimensions; this will allow for cushioning.
Refer to the following table for carton test strength
requirements.
2. Surround the instrument with polyethylene sheeting to
protect the finish of the instrument.
3. Cushion the instrument on all sides by tightly packing
dunnage or urethane foam between carton and instru
ment, allowing three inches on all sides.
4. Seal carton with shipping tape or industrial stapler.
SHIPPING CARTON TEST STRENGTH
Gross Weight (lb) Carton Test Strength (lb)
0-10 200
10-30 275
30-120 375
120-140 500
140-160 600
5-20
@
To Next Page
Loading...
