Tektronix DSA8200 Series User Manual

Command Groups
Command
Description
WFMInpre:BYT_Nr? Returns the byte width of the waveform to be
transferred to the instrument
WFMInpre:BYT_Or Sets or r eturns which byte of binary waveform
data is trans
mitted first during a waveform
data transfer to the instrument
WFMInpre:ENCdg Sets or returns the type of encoding used for
waveform data transferred with the CURVe
command
WFMInpre:NR_Pt
Sets or ret
urns the record length of the input
waveform
WFMInpre
:PT_Fmt
Sets or returns the data point format of the
incoming waveform
WFMInpre:WFMLabel
Sets or r eturns the label for the incoming
wavefor
m
WFMInpre:XINcr
Sets or r
eturns the interval between samples
of the incoming waveform
WFMInp
re:XMUlt
Sets or returns the horizontal scale factor
(horizontal units per division) of the incoming
wavef
orm
WFMIn
pre:XOFf
Sets o
r returns the horizontal position in
horizontal units of the incoming waveform
WFMI
npre:XUNit
Sets or returns the horizontal (x-axis) units of
the incoming waveform
WFMInpre:XZEro
Sets or returns the horizontal (x-axis) origin
off
set (time of first point in this instrument) of
the incoming waveform
WFM
Inpre:YMUlt
Sets or returns the vertical scale in vertical
units per division of the incoming waveform
re
turned by the previous CURVe? command
W
FMInpre:YOFf
S
ets or returns the vertical position of the
incoming waveform in divisions
WFMInpre:YSCALE Sets or r eturns the vertical unit scale factor
of the incoming waveform
WFMInpre:YUNit
Sets or returns the vertical (y-axis) units of
the incoming waveform
WFMInpre:YZEro
Sets or returns the vertical o ffset voltage of
the incoming waveform
WFMOutpre? Returns the preamble for the outgoing
waveform
WFMOutpre:BIT_Nr? Returns the number of bits (width) per
waveform point of the w aveform to b e
transferred from the instrument
2-48 DSA/CSA/TDS8X00/B Series Programmer Manual

Tektronix DSA8200 Series Specifications

General

Brand	Tektronix
Model	DSA8200 Series
Category	Test Equipment
Language	English