Other bus types. Serial bus types, such as CAN, LIN, I2C, and FlexRay, are available as purchasable options. Once purchased
and installed, the new bus types are shown in the Bus Type menu. The serial bus options also add corresponding bus trigger
capabilities to the Trigger menu.
ARINC 429 serial bus menu on page 192
Audio serial bus configuration menu on page 194
CAN serial bus configuration menu on page 196
Ethernet serial bus menu on page 198
FlexRay serial bus configuration menu on page 200
I2C serial bus configuration menu on page 202
LIN serial bus configuration menu on page 204
MIL-STD-1553 serial bus menu on page 205
Parallel Bus configuration menu on page 207
RS232 serial bus menu on page 209
SENT serial bus configuration menu on page 211
SPI serial bus configuration menu on page 213
SPMI serial bus configuration menu on page 215
See also.
Bus Trigger configuration on page 342
Bus Search configuration menus on page 230
Add Plot configuration menu
Use this configuration menu to select and plot the amplitude and time relationship of two (XY) or three (XYZ) signals, which can
be sourced from channel, math, or reference waveforms, or plot a TIE measurement eye diagram.
These plots differ from the Measurement plots (added from a Measurement configuration menu), which plot that measurement's
value, not the signal source value(s).
To open the Add Plot configuration menu, tap the Add New... Plot button.
To add a plot:
1. Select a plot type.
2. Select the signal source or sources.
3. Tap Add. You can also double tap a plot to add it to the screen. The plot is added to the screen.
Menus and dialog boxes
MSO54, MSO56, MSO58, MSO58LP, MSO64 Help 219
To Next Page
Loading...
Need help?
General
