Other bus types. Other serial bus types, such as CAN, LIN, I
2
C, and FlexRay, are available as purchasable options. Once
purchased and installed, the new bus types are shown in the Bus Type menu. The serial bus options also add corresponding bus
trigger capabilities to the Trigger menu.
ARINC 429 serial bus menu on page 192
Audio serial bus configuration menu on page 194
CAN serial bus configuration menu on page 196
Ethernet serial bus menu on page 198
FlexRay serial bus configuration menu on page 200
I2C serial bus configuration menu on page 202
LIN serial bus configuration menu on page 204
MIL-STD-1553 serial bus menu on page 205
Parallel Bus configuration menu on page 207
RS232 serial bus menu on page 209
SENT serial bus configuration menu on page 211
SPMI serial bus configuration menu on page 215
USB serial bus configuration menu on page 217
See also.
Bus Trigger configuration on page 342
Bus Search configuration menus on page 230
SPMI serial bus configuration menu
Use the SPMI bus menu (optional) to set up and display an SPMI (System Power Management Interface) serial bus waveform.
Requires option SRPM.
To add an SPMI serial bus waveform to the display:
1. Tap Add New Bus on the Settings bar.
2. Set the Bus Type to SPMI.
3. Use the menu fields and controls to configure the SPMI bus parameters.
To change the settings on an existing SPMI serial bus waveform, double-tap the SPMI bus badge to open the configuration
menu.
Menus and dialog boxes
MSO54, MSO56, MSO58, MSO58LP, MSO64 Help 215
To Next Page
Loading...
Need help?
General
