Tektronix T202 - Page 31

r
Remove Selected Reference Signals From
Display
The numer ic entry for the highest memory location
that is filled will be displayed.
Press: I SHIFT I I REF # I I 1 through 9 !
!ENTER!
Display : REF# (1 through 9)
Recall or Remove All Saved Reference
Signal(s)
D is play all saved reference signals and readout of
the highest saved reference signal. Repeat the in-
struction to remove all save reference from the
display.
EXAMPLE : Highest memory location to have a
saved reference signal is 6 when d.lling up the
save reference signals .
Press: I SHIFT! I REFS ON/OFF I
Display : REFS (1 through 6) (6) ON or REFS
OFF
Display or Remove Selected Reference Sig-
nal Readout
For a single reference display, a save reference
numeric entry is not necessary after the
I POS REF READOUT I keystroke.
Press: I POS REF READOUT 111 through 9 !
I SHIFT! I ON/OFF!
Display: POS REF RDOUT (6) 6 ON/ OFF
4-18 --------------
Positioning a Reference Signal
For a single reference display, a save reference
numeric entry is not necessary after the
I RECALL POS REF I keystroke .
UP-ARROW AND DOWN-ARROW KEYS
Press: I RECALL POS REF I []] I ENTER I
~ or[!]
Display: RCL 6 .A. or T
LEFT -ARROW AND RIGHT -ARROW KEYS
Press: I RECALL POS REF I []] I ENTER I
~ or~
Display: RCL 6 ◄ or ►
Position Reference Readout
UP - ARROW AND DOWN-ARROW KEYS
Press: I POS REF READOUT I ~ or[!]
Display: POS REF RDOUT .A. or T
LEFT -ARROW AND RIGHT -ARROW KEYS
Press: I POS REF READOUT I ~ or ~
Display : POS REF RDOUT ◄ or ►
Cursor Measurements
UP-ARROW AND DOWN-ARROW KEYS
Press: I RECALL REF READOUT! []]
I CURSOR 1 I or I CURSOR 2 ! ~ or [!]
Display: RCL REF 6 C1 or C2 .A. or T
- Operating Instructions -----
4-19