Tekvox TEK 1201-N User Manual

TEK 1201-N Next Generation Presentation Switcher
www.tekvox.com 30 sales@tekvox.com
Control TEK 1201-N from Local and Remote 4.4.16.1
This is the normal operation of the TEK 1201-N which also works with a
TekMonitor at the HDBaseT receiver.
1. Connect the RS232 port of TEK 1201-N to RS232 port of PC.
2. Send the command 50788% (serial control mode 1, factory default) via
RS232 communication software.
3. Send any control command for the TEK 1201-N from either RS232 port on
unit or HDBaseT receiver. Connect as shown below:
Control TEK 1201-N using TEKVOX Equipment

Tekvox TEK 1201-N Specifications

General

Brand	Tekvox
Model	TEK 1201-N
Category	Switch
Language	English