Teletek electronics TTE Combo - Page 40

TTE Combo Communication Module – Installation and Programming Manual
40
SIA
Code
Event Code Description Address Field
YW
Watchdog Reset
The TRANSMITTER created an internal reset.
Unused
YX Service Required
Problem with the connection to the control panel – line
is broken or the phone device terminals are not
terminated with 220k resistor - 2.1 Connection to
Burglary Alarm Control Panel.
Unused
YY Status Report
This is a header for an account status report
transmission.
Unused
YZ
Service Completed
Connection with the control panel is restored.
Unused
ZA
Freeze Alarm
Low temperature detected at premises.
Zone or point
ZB
Freeze Bypass
Low temperature detection has been bypassed.
Zone or point
ZH
Freeze Alarm Restore
Alarm condition eliminated.
Zone or point
ZJ
Freeze Trouble Restore
Trouble condition eliminated.
Zone or point
ZR
Freeze Restoral
Alarm/trouble condition has been eliminated.
Zone or point
ZS
Freeze Supervisory
Unsafe freeze detection system condition.
Zone or point
ZT
Freeze Trouble
Zone disabled by fault.
Zone or point
ZU
Freeze Unbypass
Low temperature detection bypass removed.
Zone or point