Teletek electronics TTE Combo - Page 39

TTE Combo Communication Module – Installation and Programming Manual
39
SIA
Code
Event Code Description Address Field
WS
Water Supervisory
Water unsafe water detection system condition.
Zone or point
WT
Water Trouble
Water zone disabled by fault.
Zone or point
WU
Water Unbypass
Water detection bypass has been removed.
Zone or point
XE Extra Point
Panel has sensed an extra point not specified for this
site.
Point number
XF Extra RF Point
Panel has sensed an extra RF point not specified for this
site.
Point number
XH RF Interference Restoral A radio device is no longer detecting RF Interference.
Receiver
number
XI
Sensor Reset
A user has reset a sensor.
Zone or point
XQ RF Interference A radio device is detecting RF Interference.
Receiver
number
XR
Transmitter Battery Restoral
Low battery has been corrected.
Zone or point
XT
Transmitter Battery Trouble
Low battery in wireless transmitter.
Zone or point
XW
Forced Point
A point was forced out of the system at arm time.
Zone or point
YA Bell Fault
A trouble condition has been detected on a Local Bell,
Siren, or Annunciator.
Unused
YB Busy Seconds Percent of time receiver's line card is on-line.
Line card
number
YC Communications Trouble
Problem with Main or Backup communication media.
Example: “YC1”- Problem with GPRS media; “YC2”-
Problem with LAN media. The type of the media and the
priority of transmitting is set in General Settings menu.
1 - GPRS
2 - LAN
YD Receiver Line Card Trouble A line card identified by the passed address is in trouble.
Line card
number
YE
Receiver Line Card Restored
A line card identified by the passed address is restored.
Line card
number
YF
Parameter Checksum Fail
System data corrupted.
Unused
YG
Parameter Changed
A TRANSMITTER'S parameters have been changed.
Unused
YH Bell Restored
A trouble condition has been restored on a Local Bell,
Siren, or Annunciator.
Unused
YI Overcurrent Trouble
An Expansion Device has detected an overcurrent
condition.
Unused
YJ Overcurrent Restore
An Expansion Device has restored from an overcurrent
condition.
Unused
YK Communications Restore
The transmitting of messages via Main or Backup media
is Restored.
Example: “YK1”- GPRS communication media restored;
“YK2”- LAN communication media restored.
1 - GPRS
2 - LAN
YM
System Battery Missing
TRANSMITTER/RECEIVER battery is missing.
Unused
YN
Invalid Report
TRANSMITTER has sent a packet with invalid data.
Unused
YO Unknown Message
Impossible translation of the received CID event
Example: “YO1205” – the translation of CID 1205 is
missing.
CID code
YP Power Supply Trouble
TRANSMITTER/RECEIVER has a problem with the power
supply.
Unused
YQ Power Supply Restored
TRANSMITTER'S/RECEIVER'S power supply has been
restored.
Unused
YR
System Battery Restoral
Low battery has been corrected.
Unused
YS
Communications Trouble
RECEIVER and TRANSMITTER.
Unused
YT
System Battery Trouble
Low battery in control/communicator.
Unused