Telit Wireless Solutions LE910C1-AP Hardware Design Guide

LE910Cx Hardware Design Guide
1VV0301298 Rev.40 Page 124 of 149 2023-03-16
Not Subject to NDA
Model
LE910C1-AP
LE910C1-WWX
LE910C1-WWXD
LE910C4-WWX
LE910C4-WWXD
NCC safety
warning
statmement
“減少電磁波影
響，請妥適使用
”
“減少電磁波影
響，請妥適使用
”
“減少電磁波影
響，請妥適使用
”
“減少電磁波影
響，請妥適使用
”
“減少電磁波影
響，請妥適使用
”
Table 49: Taiwan NCC labeling requirements
EMEA Approvals
13.3.1. EU RED Declaration of Conformity
In accordance with the above Approval Compliance Summary table, where applicable
(green ball), hereby, Telit Communications S.p.A declares that the equipment is in
compliance with the Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet
address: https://www.telit.com/red
Text of 2014/53/EU Directive (RED) requirements can be found here:
https://eur-lex.europa.eu/legal-content/EN/TXT/?uri=CELEX:32014L0053
13.3.1.1. RED Antennas
This radio transmitter has been approved under RED to operate with the antenna types
listed below with the maximum permissible gain indicated. The usage of a different
antenna in the final hosting device may need a new assessment of host conformity to
RED.
Model
Antenna Type
LE910C4-EU
LE910C1-EU
LE910C1-EUX
Omnidirectional
Atel-Cab T-AT305
Antenna Gain 2.14 dBi
LE910C4-WWX
LE910C1-WWX
LE910C4-WWXD
LE910C1-WWXD
Omnidirectional
Hankook Type WE14-LF-07
Antenna max gain: 4 dBi
Table 50: RED Antenna Type used for module type approval

Telit Wireless Solutions LE910C1-AP Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C1-AP
Category	Control Unit
Language	English