LE910Cx Hardware Design Guide
1VV0301298 Rev.40 Page 127 of 149 2023-03-16
Not Subject to NDA
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines. This
transmitter must not be co-located or operate in conjunction with any other antenna or
transmitter. The antenna should be installed and operated with a minimum distance of
20 cm between the radiator and your body
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, according to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used per the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by taking one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Information for the OEMs and Integrators
The following statement must be included with all versions of this document supplied to
an OEM or integrator but should not be distributed to the end user.
1. This device is intended for OEM integrators only.
2. Please see the full Grant of Equipment document for other restrictions
Manual Information to the End User
The OEM integrator should be aware not to provide information to the end user on how to
install or remove this RF module in the user’s manual of the end product which integrates
this module. The end user manual shall include all required regulatory
information/warming as shown in this manual
Information on test modes and additional testing requirement
To Next Page
Loading...
Need help?
General
