Teltonika RUT9 Series User Manual

Field name
Explanation
1.
Protocol
Select the protocol used for the connection.
2.
Mode
Select the role of the connected device. It can either wait for incoming
connection (Server) or initiate the connection (Client).
3.
Server Address
Specify IP address or host name of the remote server to connect to.
4.
Keepalive interval
Specify interval in seconds that will be used to keep the connection alive.
5.
TCP port
Specify port number that will be used to listen for incoming connections
(Server) or port of the remote server (Client)
8.5.3.3 Modem mode
In this mode the router imitates dial-up modem. Connection to TCP/IP network can be established using AT
commands.The connection can be initiated by the device connected via serial interface with ATD command:
ATD<host>:<port>. If Direct connect settings are specified the connection to the server is always active. Data mode can
be entered by issuing ATD command.Incoming connection is indicated by sending RING to the serial interface.
Field name
Explanation
1.
Direct connect
Specify IP address (or host name) and TCP port of the remote server.
2.
TCP port
Specify TCP port number that will be used to listen for incoming
connections. Leave it empty to disable incoming connections.
89

Teltonika RUT9 Series Specifications

General

Brand	Teltonika
Model	RUT9 Series
Category	Network Router
Language	English