Teltonika RUT9 Series User Manual

This is the AT command set used in Modem mode of the serial interfaces:
Command
Description
Usage
A
Answer incoming call
To answer incoming connection: ATA
D
Dial a number
To initiate data connection: ATD<host>:<port>
To enter data mode with Direct connect settings: ATD
E
Local echo
Turn local echo on: ATE1
Turn local echo off: ATE0
H
Hang up current call
To end data connection: ATH
O
Return to data mode
To return to data mode from command mode: ATO
Z
Reset to default
configuration
To reset the modem to default configuration: ATZ
8.5.3.4 Modbus Gateway mode
Field name
Explanation
1.
Listening IP
IP address on which Modbus gateway should wait for incoming
connections
2.
Port
Port to use for communications
3.
Slave ID
ID of the slave device connected to router
8.6 VPN
8.6.1 OpenVPN
VPN (Virtual Private Network) is a method for secure data transfer through unsafe public network. This section
explains how to configure OpenVPN, which is implementation of VPN supported by the router.
A picture below demonstrates default OpenVPN configurations list, which is empty, so you have to define a new
configuration to establish any sort of OpenVPN connection. To create it, enter desired configuration name in “New
configuration name” field, select device role from “Role” drop down list. For example, to create an OpenVPN client with
configuration name Demo, select client role, name it “Demo” and press “Add New” button as shown in the following
picture.
90

Teltonika RUT9 Series Specifications

General

Brand	Teltonika
Model	RUT9 Series
Category	Network Router
Language	English