8.
5.2.6 Number of devices in RS-485 Network
One RUT9xx RS-485 driver is capable of driving maximum 32 receivers, provided that receiver input impedance is
12kΩ. If receiver impedances are higher, maximum number of receivers in network increases. Any combination of
receiver types can be connected together, provided their parallel impedance does not exceed R
Load
> 375Ω.
8.5.3 Modes of different serial types in RS232 and RS485
8.5.3.1 Console mode
In this mode the serial interface set up as Linux console of the device. It can be used for debug purposes, to get
the status of the device or to control it.
8.5.3.2 Over IP mode
In this mode the router provides connection to TPC/IP network for the devices connected via serial interfaces.
88
To Next Page
Loading...
Need help?
General
