You can set custom settings here according to your VPN needs. Below is summary of parameters available to set:
Switches configuration on and off. This must be selected to make configuration active.
Selects virtual VPN interface type. TUN is most often used in typical IP-level VPN connections,
however, TAP is required to some Ethernet bridging configurations.
Defines a transport protocol used by connection. You can choose here between TCP and UDP.
Defines TCP or UDP port number (make sure, that this port allowed by firewall).
This setting enables LZO compression. With LZO compression, your VPN connection will
generate less network traffic; however, this means higher router CPU loads. Use it carefully
with high rate traffic or low CPU resources.
Selects Packet encryption algorithm.
Sets authentication mode, used to secure data sessions. Two possibilities you have here:
“Static” means, that OpenVPN client and server will use the same secret key, which must be
uploaded to the router using “Static pre-shared key” option. “Tls” authentication mode uses
X.509 type certificates. Depending on your selected OpenVPN mode (client or server) you
have to upload these certificates to the router:
To Next Page
Loading...
Need help?
General
