Tenda AC18 - Page 94

- 89 -
Parameter
Description
Target
Network
It specifies the IP address of a packet destination.
Subnet Mask
It specifies the subnet mask of the IP address of a packet destination.
Gateway
It specifies the IP address of the next hop of packets transmitted from
the router.
Interface
It specifies the WAN port of the router for transmitting packets.
Action
It allows you to add a static route.
Application Scenario
See the following figure. You want to access the internet and the LAN server at the same time.
Nevertheless, the default gateway of AC18 is the LAN IP address of router 1 (which is
192.168.1.1), making the LAN server inaccessible. In this case, you can configure a static route
on AC18 to enable your computer to access the LAN server.
Configuration
Step 1 Choose Advanced Settings > Static Routing.