- 80 -
4. Set Port to the port number of the web service, which is generally 8080. You can also
select a port number from the 1024~65535 range but the port number must not be the
same as that of the virtual server.
5. Click Save.
Step 3 Access the web UI of AC18 on computer 2.
On computer 2, enter http://102.33.66.88:8080 or http://tenda.dyndns.org:8080 in the
address bar of a web browser.
---End
3.8.6 Virtual Server
If computers are connected to the router to form a LAN and access the internet through the
router, internet users cannot access the hosts on the LAN. Therefore, the servers, such as web
servers, email servers, and FTP servers, on the LAN are inaccessible to internet users. To
enable internet users to access a LAN server, enable the virtual server function of the router,
and map one service port of the virtual server to the IP address of the LAN server. This
enables the router to forward the requests arriving at the port from the internet to the LAN
server.
To configure the virtual server function, choose Advanced Settings > Virtual Server. By default,
the function is disabled.
The following table describes the parameters.
To Next Page
Loading...
Need help?
General
