Tenda AC19

104
Configure IPv6 tunnel
⚫
Devices at both ends of the tunnel must support the dual stack protocol.
⚫
The WAN IPv4 address of the routers must be a public IP address.
6in4 tunnel
Log in to the web UI of the router, and navigate to IPv6. Set the connection type to 6in4 Tunnel,
enter required parameters and save the configurations.
Parameter description
Parameter
Description
Remote IPv4 Address
It specifies the WAN IPv4 address of the dual stack router at the peer side.
Local IPv6 Address
It specifies the IPv6 address of the LAN, which needs to be customized.
6to4 tunnel
Log in to the web UI of the router, and navigate to IPv6. Set the connection type to 6to4 Tunnel
and save the configurations.
6rd tunnel
Log in to the web UI of the router, and navigate to IPv6. Set the connection type to 6rd Tunnel,
enter required parameters and save the configurations.