It specifies the ingress IP address of the next hop route after the data packet exits
from the interface of the router.
0.0.0.0 indicates that the destination network is directly connected to the router.
11.8.2 Add a static route rule
Scenario: You have an AC23 and another two routers. Router1 is connected to the internet and its
DHCP server is enabled. Router2 is connected to an intranet and its DHCP server is disabled.
Goal: You are able to access both the internet and intranet at the same time.
Solution: You can configure the static route function to reach the goal.
Assume the LAN IP addresses of these devices are:
− AC23: 192.168.0.1
− Router1: 192.168.10.10
− Router2: 192.168.10.20
The information about the intranet:
− IP address: 172.16.105.0
− Subnet mask: 255.255.255.0
Configuring procedure:
Step 1 Start a web browser on a device connected to the router and visit tendawifi.com to log in
to the web UI of the router.
Step 2 Refer to Access the internet with a dynamic IP address to configure the internet access for
AC23.
To Next Page
Loading...
