1. Internet connection Type: Select PPPoE.
2. PPPoE User Name: Enter the User Name provided by your ISP.
3. PPPoE Password: Enter the password provided by your ISP.
4. MTU: Maximum Transmission Unit. DO NOT change it from the
factory default of 1492 unless necessary. You may need to
change it for optimal performance with some specific websites or
application software that cannot be opened or enabled; in this
case, try 1450, 1400, etc.
5. Service Name: Description of PPPoE connection. Leave blank
unless otherwise required.
6. Server Name: Description of server. Leave blank unless
otherwise required.
7. Connect Automatically: Connect automatically to the Internet
after rebooting the system or connection failure.
Connect Manually: Require the user to manually connect to the
Internet before each session.
Connect On Demand: Re-establish connection to the Internet only
when there is data transmission.
Connect During Specified Time Period: Only connect to Internet
during a specified time period.
8. OK: Click it to save all your settings.
To Next Page
Loading...
