Tenda F300 User Manual

Wireless N300 Home Router
45
Chapter 4 Wireless Settings
4.1 Wireless Basic Settings
Here you can expand your wireless coverage with the following
modes: Wireless AP (default mode) and WDS.
1. Wireless Access Point (AP): Select this mode if you want to
convert an existing wired network to a wireless network so as to
extend Internet access to wireless clients.
2. WDS Bridge Mode: wireless distribution system (WDS) is a
system enabling the wireless interconnection of access points in
an IEEE 802.11 network. It allows a wireless network to be
expanded using multiple access points without the traditional
requirement for a wired backbone to link them. Select this mode
if you want to extend an existing wireless network. The two
modes are described as below:

Tenda F300 Specifications

General

Frequency	2.4GHz
Data Rate	300Mbps
Ports	1x 10/100Mbps WAN port, 3x 10/100Mbps LAN ports
Wireless Standards	IEEE 802.11n
Security	WPA/WPA2
Button	Reset button
Antenna	2x 5dBi fixed antennas
Weight	200g