For example:
As seen in the figure above, PC1 and PC2 access Internet via a
wireless connection to Router 1. While PC3 and PC4 are too far to
directly connect to Router 1 for Internet access. Now you can use
the WDS bridge feature to let PC3 and PC4 access Internet.
Before you get started:
1. View and note down the wireless security settings: security mode,
cipher type, security key, etc. on Router 1.
2. Verify that DHCP server is enabled on Router 1.
3. Set the LAN IP address of Router 2 to a different address yet on
the same net segment as Router 1.
To Next Page
Loading...
