the right side of the steering column toward you and moving it up one position. R1 position
attained by pulling lever on the right side of the steering column toward you and moving in
down one position. Slowly release foot brake to begin travel. Use the throttle pedal to
increase speed only if necessary. All unloading should be done at slowest speed possible.
Use the steering wheel to control direction of front tires. Use the brake pedal to stop. If
necessary, you may use rear steer, if equipped. Toggle switch to move tires left or right.
When equipment is on the ground, make sure front and rear tires are returned to center
position. Move transmission lever to neutral, apply parking brake using dash switch and
release the foot brake. Turn the engine off.
Return outrigger steps to operational position, see Step Installation on page 51.
121P/N 12261-319 REVISED: August 2012
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
