Terex RT200-1 - Machine Maintenance Checklist

Machine Maintenance Checklist
DAILY CHECK (8 HOURS)
___ Perform Daily Lubrication ___ Drain Air Tanks
___ Check Hydraulic Reservoir Fluid
Level ___ Check Wire Rope And Related Components
___ Fill Fuel Tank ___ Check Air Cleaner
___ Check Engine Oil Level ___ Check Controls
___ Check Coolant Level
___ Check Instruments, Gauges, & Safety
Equipment
___ Check Hydraulic Cylinder
Mounting Bushings And Pins ___ Make Overall Visual Inspection
___ Check Hydraulic Components ___ Torque Wheel Nuts First 50 Miles*
___ Check Transmission Oil Level ___ Check Anti-Two Block System
___ Check Axle Lockout System
___ Check Engine Manufacturer’s Manual For
Additional Maintenance Requirements
___ Drain Fuel Filters or Water
Separator
___ Ensure Swing Brake Is Able To Hold Against
Full Torque of Swing Motor
___ Check Boom Front Slider Pads
WEEKLY CHECK (40 HOURS)
___ Perform The Daily Check ___ Check Hydraulic Cylinders and Rods
___ Perform Weekly Lubrication ___ Check Torque on Wheel Lug Nuts
___ Check Swing Reducer Oil Level ___ Make Thorough Inspection Of Wire Rope
___ Perform Initial Axle Oil Change*
___ Make Initial Replacement Of Hydraulic Return
Line Filter*
___ Check Axle Oil Level (after initial
change)
___ Visually Inspect All Structural Members And
Welds For Cracks, Alignment and Wear
___ Check Battery Condition
___ Check Boom For Wear, Cracked Welds, Align-
ment And Missing Or Illegible Decals
___ Check Tire Pressure and Condition
___ Check Engine Manufacturer’s Manual For Addi-
tional Maintenance Requirements
___ Check Air System Safety Valve
___ Clean Machine Weekly If Salt Covered To
Prevent Rust And Corrosion
* Interval given applies only to initial
period of use (break-in).
___ Torque Swing Bearing Bolts *
Maintenance
134 P/N 12261-319 REVISED: August 2012
Courtesy of Crane.Market