Transmission Storage
PRESERVATIVE SELECTION
When transmissions are to be stored or remain inactive for extended periods of time,
specific preservative methods are recommended to prevent rust and corrosion damage.
The length of storage will usually determine the preservative method to be used. Various
methods are described below.
STORAGE NEW UNITS
New units contain preservative oil when shipped for Funk and can be safely stored for 6
weeks without further treatment. Refer to the Funk Transmission manual for additional
information.
STORAGE, 30 DAYS TO 1 YEAR - WITHOUT OIL
1. Drain Oil.
2. Seal all openings and breathers, except oil drain hole, with moisture-proof
cover or tape.
3. Coat all exposed, unpainted surfaces with Nox Rust X-110.
4. Atomize or spray 4 ounces of Nox Rust VCI No. 10 oil, or equivalent, into the
transmission through the oil drain hole. Install the drain plug.
5. If additional storage time is required, (3) and (4) above should be repeated at
yearly intervals.
*Nox Rust is a preservative additive manufactured by the Daubert Chemical Company,
Chicago, Illinois. Motorstor is covered by US Military Specifications MIL-L-46002 (ORD)
and MIL-1-23310 (WEP).
Maintenance
188 P/N 12261-319 REVISED: August 2012
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
