Restoration to Service
Refer to
“Restoring Engine to Service” on page 190, and “Restoring Transmission to
Service” on page 191, for the procedures required to restore these components to service.
Remove the MACHINE from storage via the following procedure:
1. Remove preservative lubricants from all surfaces.
2. Check all fluid levels, adding or draining as required.
3. Lubricate the machine according to
Lubrication Chart on page 123, making
certain that all points with grease fittings are lubricated.
4. Make a thorough visual inspection of the entire machine, placing special
emphasis on the condition of all hydraulic hoses.
189P/N 12261-319 REVISED: August 2012
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
