Seat Belts
SOME SUGGESTED USAGE AND MAINTENANCE INSTRUCTIONS FOR SEAT BELTS
1. Wear your lap belt low and snug.
2. Manually adjustable lap belts and shoulder harnesses are adjusted by pulling the loose
end of the webbing through the buckle or adjuster.
3. Seat belts using automatic-locking or emergency-locking retractors are self-adjusting.
4. Hand wash webbing with warm water and mild soap. Rinse thoroughly and dry in the
shade.
5. Do not bleach or re-dye, because such processing may severely weaken the assembly.
6. Inspect seat belt assemble frequently. Anytime it does not operate properly, or if there
are any defects in the webbing (i.e. torn or frayed), the seal belt must be replaced.
7. For a non-locking retractor belt, completely extend the lap belt from the retractor(s).
After adjusting the belt snugly (see # 2 above), attempt to pull additional webbing from
the retractor. If no additional webbing can be pulled from the retractor after
adjustment, then the seat belt is adjusted properly.
Safety
50 P/N 12261-319 REVISED: August 2012
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
