Engine Maintenance
For Cummins engine maintenance refer to Cummins Operation and Maintenance Manual
Engine productivity, longevity, and low-cost performance depend on a regular program of
periodic maintenance. The materials presented here are listed in accordance with the
Machine Maintenance Checklist on page 134.
As a part of each periodic check, refer to the engine manufacturer’s manual for engine
maintenance requirements. When servicing the engine, the engine manufacturer’s
recommendations take precedence over those in this manual, should any discrepancy be
noted.
DAILY:
FUEL LEVEL
The fuel tank is located on the left side of the machine. Keep the tank as full as possible to
minimize condensation in cold weather.
Use grade No. 2 diesel fuel. The tank capacity is 80 gallons.
ENGINE OIL LEVEL
The engine oil level is checked with the dipstick located on the left side of the engine (right
side of machine). DO NOT check the oil level while the engine is running nor immediately
after stopping the engine. For an accurate reading, allow 15 minutes for the oil to drain into
the sump before checking. Keep the oil level as close to the full mark as possible. DO NOT
OVERFILL
Never operate the machine when the oil is above the full mark or below the low
mark.
137P/N 12261-319 REVISED: August 2012
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
