17
BURN HAZARD
Contact with hot
surfaces can cause
burns.
Allow surfaces to
cool before servicing.
18 - Inside Battery Box
This unit is furnished with an alternator.
Observe the following carefully
1. Disconnect all wires at the alternator
before doing ant welding on this unit.
2. Welding and improper connections
cause instantaneous alternator damage.
3. Disconnect all wires at alternator before
disconnecting or charging battery.
4. Do not interchange positive (+) and
negative (-) battery leads.
5. Do not polarize alternator.
6. Do not ground field circuit except as
shown on alternator.
7. Do not shorten or alter wiring in any
way. Wire lengths and gauges are sized
per engine manufacturer's specification.
8. Do not disconnect battery when
alternator is running.
9. All crimped, soldered, and bolted
connections must be kept clean and
tight.
Safety
30 P/N 12261-319 REVISED: August 2012
Courtesy of Crane.Market
To Next Page
Loading...
