PLANNING THE JOB
11. Determine the lift radius, boom angle and the rated lifting capacity of the crane.
12. Always pre-plan the course of each lift to determine the safest method to reach the
load’s target destination.
13. Identify the location of gas lines, power lines, or other structures and determine if the
crane or structures need to be moved.
14. Ensure that the supporting surface is strong enough to support the machine and load.
15. Establish special safety precautions, if necessary.
16. Consider the weather conditions.
17. Keep unnecessary people and equipment away from the work area.
18. Position machine to use shortest boom and radius possible.
OPERATOR SAFETY CHECK
1. Safety related items must be in place.
2. Check machine log book, to see if periodic maintenance and inspections have been
performed.
3. Ensure that necessary repairs have been completed.
4. Inspect wire rope for damage (kinks, broken wires etc.)
5. Be sure no unauthorized field modifications have been made.
6. Check for air and hydraulic oil leaks.
7. Check that all controls are in the neutral position before starting engine.
8. After starting engine, check all gauges and indicators for proper readings.
9. Test all controls.
10. Check brakes and clutches.
11. Check hoist brakes by lifting a load a few inches off the ground and holding it.
OPERATOR AIDS CHECK
Ensure that the items listed below are in place and functioning properly.
1. Boom hoist upper angle limit switch.
(Continued on next page ...)
35P/N 12261-319 REVISED: August 2012
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
