Before erecting or stowing the jib, ensure that no personnel or obstacles are in
the swing path of the jib.
ERECTING THE JIB
1 Jib Storage Brackets 5 Anti Two-Block Switch
2 Jib Mounting Pins (4) 6 Guide Rope
3 Anti Two-Block Plug 7 T-Handle
4 Anit Two-Block Socket
1. Extend and set the outriggers.
2. Rotate the upper structure to the “over front” position.
3. Retract the boom completely.
4. Boom down to minimum boom angle to allow ease of installation of the jib pins. If
necessary raise rear outriggers till boom head can be reached from ground level.
5. Install the upper and lower jib mounting pins in the right side of the boom head.
6. Attach a guide rope to the eye on the bottom tip of the jib.
7. Extend outriggers if retracted, to bring crane back to level. Raise the boom to horizontal.
8. Pull down and rotate the T - handle to unlock the jib from the storage bracket.
61P/N 12261-319 REVISED: August 2012
Courtesy of Crane.Market
To Next Page
Loading...
