ITEMS TO BE
INSPECTED &
CHECKED
INSPECTION
CODE
SATISFACTORY ADJUST REPAIR
AIR CLEANER
ELEMENT
W
CLUTCH & BRAKE
LINKAGE & PINS
W
WHEEL LUG NUT
TORQUE
W
FAN BELT TENSION W
STRUCTURAL
MEMBERS & WELDS
W
BOOM INSPECTION W
BATTERIES &
STARTING SYSTEM
M
ALCOHOL
EVAPORATOR
M
CHROMED CYLINDER
RODS
M
SWING BEARING
BOLT TORQUE
S
MACHINERY GUARDS S
LOAD CHART &
SAFETY WARNINGS
S
BRAKE RESERVOIR M
NOTES:
1. Indicate inspection result by checking in the satisfactory, adjust, or repair boxes provided.
2. When appropriate, enter your diagnosis on back of page for repairs or adjustments made.
H Inspect OVERALL machine (including carrier) for cracks, weld separation, leaks,
damage, vandalism.
INSPECTION CODE
INTERVALS
D - DAILY M - MONTHLY W - WEEKLY S - SEMI-
ANNUALLY
Daily Pre-Start Items to be Checked
The following items should be checked each day before start-up and the start of operations.
ENGINE OIL The level should be at the full mark.
COOLANT The level should be near the top of the radiator tank.
LEAKAGE Make a ground check below the machine for signs of leaks.
81P/N 12261-319 REVISED: August 2012
Courtesy of Crane.Market
To Next Page
Loading...
