ACCESSING THE OPERATOR ALARMS
To access the Operator Alarms from the main working screen, press the operator alarms
push button (item 24). The Information Screen will then show the current status of the alarms.
The four operator alarms are shown below followed by the number identity of the push
button that controls each alarm. These buttons are called out in the illustration above.
- Minimum Boom Angle (item 28)
- Maximum Boom Angle (item 29)
- Maximum Boom Length (item 25)
- Maximum Tip Height (item 27)
Each push button operates as a toggle switch turning the alarm "ON" or "OFF."
To activate or deactivate an alarm:
• If the alarm is OFF, press the appropriate push button to turn the alarm ON.
• If the alarm is ON, press the appropriate push button to turn the alarm OFF.
Refer to page 25 for a discussion on minimum and maximum boom angles and page 26 for
maximum boom length and maximum tip height.
Return to the main screen by pressing the operator alarm push button (item 24) two times.
93
REVISED:
To Next Page
Loading...
