Borehole completed – cannot save new record
3.6.4 Discrete mode setup wizard
This mode is useful to those how only wishes to obtain single measurement at fixed depth
on borehole cores. The sequence for the discrete mode remains the same as described in
the section 3.4.1 for the Measure mode. What is new for the discrete mode is the added
benefit of collecting depth information to each stored readings. The operator will be able
to associate the Borehole ID and the Depth interval to each new reading collected. In this
mode, the depth interval is used as constant for incrementing depth for each successive
reading.
If a New borehole is not already been selected, use SBP▼ or SBP▲ to highlight this
mode in the borehole options and select it with the use of LBP▼ or LBP▲.
Use SBP▼ or SBP▲ to highlight the Discrete mode and then use LBP▼ or LBP▲ to
select it. A new borehole setup wizard will be activated as shown below.
1) Borehole ID
Enter the borehole identification
Borehole ID – Discrete mode
46
To Next Page
Loading...