With PIN
PIN Installation:
Remove the thread protection screw from head of the KT-10 v2. Install the PIN in the
place of the thread protection screw. Ensure that the PIN is threaded all the way into the
housing. Remember to enable the PIN mode in the Setup menu.
Step 1: With the KT-10 v2 in Free Air, use SBP▲ to start the measurement process.
After about 1 second you will hear a short sound indicating the free air
measurements are complete.
Step 2: Immediately place the KT-10 v2 on the sample’s surface keeping the coil parallel
to the sample then use SBP▲. When the reading on the sample is complete you
will hear a sound; this sound is different then the one heard during the
free air measurements.
Step 3: Then immediately position the KT-10 v2 in free air once again for the final free
air measurements. Wait for the final sound, which will be the same as the first
tone heard in Step 1. This sound will indicate the final free air measurements are
complete and the reading(s) will be displayed on screen.
3.4.2 Store a reading
To store the reading, there are two different options available; quick save and save
with a voice note.
Quick Save: With the results displayed on screen, you can quickly store the
reading by using LBP▲.
Save with voice note: To store the reading with an optional voice record use LBP▼.
This will invoke the voice recorder and the screen shown in Figure
22 will be displayed. Position the KT-10 v2 about 10 cm from
your mouth and speak at a normal volume. You can end the voice
record by using either SBP▼ or SBP▲ or, by allowing the time
to elapse (45 seconds).
27
To Next Page