Advanced
Provides access to the meter Calibration and QA parameters.
Figure 19: Advanced
Show raw data: A debug tool that monitors the frequency & amplitude
of the measuring coil; this feature is primarily used at the factory.
Borehole mode
The Borehole mode allows user to integrate depth information to the data being collected
in both the Measure and the Scanner mode. In the Setup menu, the Borehole mode
option can be OFF or ON. When the Borehole mode is ON, the main menu will list
Borehole as a method of measurement.
Borehole Mode OFF Borehole Mode ON
Main Menu
Units
Users can obtain magnetic susceptibility measurements in either SI or CGS
units; while conductivity measurements can be in either S/m or Ω.m units
* When Borehole Mode is enabled, unit of measure for distance can be selected
Main Menu:
This selection will take you back to the Main Menu.
24
To Next Page